Title Page Previous Next Contents | Installing the 2X Gateway Manually

Installing the 2X Gateway Manually

Before starting the installation procedure, please make sure that you are logged on with administrator rights, and that the system requirements are met.
  1. Log on to the machine where the 2X Secure Client Gateway will be installed.
  2. Run the 2X ApplicationServer setup program by double clicking on the ‘2XAppServer.msi’ file. A welcome dialog will appear. Close all other Windows programs and click ‘Next’.
2X ApplicationServer Setup Program welcome screen.
  1. Accept the License Agreement and click ‘Next’
The End-User License Agreement.
  1. Select the location where you want to install the 2X Secure Client Gateway and click ‘Next’.
Choosing the location where 2X Secure Client Gateway will be installed.
  1. Select the ‘Custom’ as the Installation type.
Select Installation type: Custom.
  1. Select the ‘2X Secure Client Gateway’ only, as shown in the figure below and click ‘Next’.
Select only the 2X Secure Client Gateway for installation.
  1. To start the actual installation process, click ‘Install’.
Starting the installation program.
  1. Setup will copy the required files and will create the service on the machine. After finishing you will see the Launch Configuration Utility screen.
Post-Installation status screen.
After the installation is complete (remotely or manually), you should see the ‘2X Secure Client Gateway’ service listed under ‘Services’ on the server where the service has been installed.
The 2X Secure Client Gateway Service
NOTE:  ApplicationServer ver.8 gateways are automatically detected and can be pushed from the 2X Console. Publishing Agents can also be pushed from the 2X Console, but this is a procedure for creating a backup (slave) Publishing Agent.